HANDS ON CLASS
S&W Revolver

The DF&R Smith and Wesson Revolvers class consists of approximately 15
hours of lecture and 25 hours of bench time.

During the S&W Revolver class, students will learn DF&R of the Smith  and Wesson Double action swing out cylinder revolvers. Including timing, ranging, aligning crane, removal of ends-hake and so much more. Also smooth polish and target trigger job.

PREREQUISITE

Successful completion of the Handguns section of the course.

REQUIRED FIREARMS

To provide a complete and thorough course, the students will be working on a large variety of differently designed extractors. Therefore, students will need to bring a large number of firearms to include the following:

  • Minimum of ONE S&W Double Action Swing-out cylinder Revolver
    Have more? Bring them – More is better!

required and additional tools

Basic Tool Kit from the Tool list PLUS

  • Hand Window File (Brownell’s carry these)
  • 2 Oz. Ball Peen Hammer
  • 6” Barrett File
  • 6” and 8” Bastard Files
  • Dial Caliper
  • Welding goggles
  • Flat head Screwdriver with head a minimum of .250 wide and shaft of
    at least 4” in length.
  • We will be modifying this into a tool. An inexpensive or used and well -worn
    screwdriver works well for this.
  • Toothbrush (for gun cleaning….NOT your teeth)
  • Dead Blow Hammer
  • Babbitt bar (Brownells
  • Ammo for guns to be used in class.
  • Shooting Glasses
    Hearing protection (For test firing…NOT during Ken’s lectures)
  • Eye protection
  • *Extra set of springs for the model of gun bringing to class.
  • *Note: This is not required but may come in handy if the set in the firearm gets ruined