Does the chamfered end of the firing pin striker go towards the hammer? I believe that’s the right way, but not sure. Took apart for a clean & oil and didn’t pay good enough attention to it.
Yes, that way the locking block can drag against it and still close. Ken
Reply:
Ken, The firing pin striker has a slot in it for the retaining pin. The notch is not centered. The chamfered end is the shortest end. This is the end I have towards the firing pin. When I squeeze the lever I can see the locking block rise and the bolt move slightly forward like it’s supposed to. Everything seems to function properly, safety etc. The chamfered end pushs the firing pin forward as it locks up, the bottom of the firing pin is also chamfered. I think this is correct?
Answer:
That sounds correct to me. If the long end is forward it will stick into the bolt and the locking block cannot lower.
